99.6mph Custom Modified RC Car

  • Uploaded 4 years ago in the category Cars & Trucks

    So close to 100mph! It went 99.6mph, I think I need a higher C rated battery.
    It flipped and broke part of the front splitter so I'm going to make a few ch

    ...

    So close to 100mph! It went 99.6mph, I think I need a higher C rated battery.
    It flipped and broke part of the front splitter so I'm going to make a few changes and try it again.


    So here is the setup:
    Shortened XO-1 chassis, it's now a 1/8th scale car so I can use an OFNA McLaren body.
    Mamba Monster 2200kv motor, not the XO-1 motor.
    6s Lipo
    29t pinion 46t spur
    Futaba gyro

    I ended up removing the rear wing because it caused too much drag.

    Even without the wing the car still ended up flipping, you can see at the end of the video the car goes airborne and does about 3 flips in the air at about 80-90mph.

    Also, the numbers on the timers aren't from this car, it's too low to trip the sensors so I can't get a reading for a 1/4 mile run.

    www.performancedrivingnetwork.com

    HTC Facebook: www.facebook.com/HighTechCorvettefans
    PDN Facebook: www.facebook.com/pages/Performance-Driving-Network/483647874985831
    HPD Facebook: www.facebook.com/HoustonPerformanceDriving

    Twitter: twitter.com/HTCorvette

show more show less
    Comments (0)